Cody - elbow question

[David Delaney]

I hope I am not giving too much away here when I ask questions Cody!

I have just finished the elbows.  Now, since they are going to be laying against each other and I wasn't sure in the manual, on the top and the bottom of the elbow pieces (when they are attached) are two abecs on the top, 2 abec on the bottom.  Is there supposed to be the four abec in between the two pieces as well?

Picture : (abecs are the bearings - obviously)
___abec____abec___
|                                 |
|__abec____abec___|
___abec____abec___
|                                 |
|__abec____abec___|

Like this?  With the 4 sandwiched in between?  Are they redundant because of the four outer bearings?  I was thinking it would save bearings without them because the top two and the bottom two could hold and swivel the elbow...what do you think?

Thanks

[Cody Deegan]

No there are not supposed to be four in the middle.

[David Delaney]

Thanks, that saves me the time and effort!  It also is good because I made a mistake on one of the holes and it is too big and the bearing drops through...I won't use that one and instead turn it over and use the others.